Tactical Wear-Resistant Hiking Work Trousers
Tracking
Tracking
Keep an eye on your gear.
Simply enter the tracking number sent to your email to see exactly where your package is and when it is estimated to arrive.
Note: It may take 24-48 hours for tracking information to update after your order has been dispatched.
Knees go first. These have a panel over them.
The knee is where work trousers die. Kneeling on gravel, on a concrete slab, on a steel deck or in the back of a trailer, you grind through the knee long before the seat or the pockets give up. Then you are buying another pair mid-season, or you are turning up to a job with a hole in your leg and getting sent home to change.
These are cut for that. The fabric shows a ripstop grid, the knee is articulated so the leg bends without dragging the cloth tight across it, and there is a second layer of textured fabric sitting over the knee and running down the shin — the two places that actually wear out. Pockets sit on the thigh, the lower leg and the seat, all under flaps, so gear stays put when you are climbing in and out of a machine all shift.
What the supplier does not publish is a number. There is no Martindale abrasion figure, no denier, and no fibre percentages printed anywhere on the artwork. So this page describes the construction and leaves the judgement to you. We are not putting a durability figure on a page that nobody printed.
What It Does
- Takes the kneeling: on gravel, concrete or a steel deck the extra knee and shin layer takes the grinding instead of the base cloth.
- Bends when you bend: shaped knee seams and a yoke across the seat mean squatting, climbing a ladder or getting into a cab does not pull the whole leg tight.
- Carries the small gear: flapped thigh and lower-leg pockets keep a multi-tool, a roll of tape or a notepad off your back pockets when you are sitting down for hours.
- Takes a proper belt: conventional belt loops plus webbing loops on the waistband, so a wide rigger's belt sits where you put it instead of dragging the waistband down.
- Blends in or stands out: eight colourways from black and grey through khaki, army green and multicam — pick what suits where you work rather than announcing you.
Key Features
- Ripstop weave: the grid is visible in the fabric, so a nick is less likely to run away into a tear.
- Knee and shin panels: a second layer of textured fabric over the knee and down the shin, in the same colour as the trousers.
- Articulated knee: shaped seams at the knee so the leg follows you rather than fighting you.
- Seat yoke: a shaped panel across the seat instead of a flat back, which is what stops the waistband pulling down when you squat.
- Zip fly, button waist: a standard zip fly closing to a button at the waistband.
- Flapped cargo pockets: thigh and lower-leg pockets, each with a flap and a closure tab.
- Flapped rear pockets: so a phone or a notepad does not walk out of the seat when you sit down.
- Hem tabs: a tab at each cuff to snug the leg down over a boot.
- Eight colourways: black, grey, dark grey, khaki, army green, dark green, camouflage and CP multicam.
- Five sizes: M through to 3XL, with a full measurement chart in centimetres in the Specs tab.
Limits
- Not certified workwear: no flame resistance, no cut resistance, no hi-vis. Nothing on this garment is tested or marked to ISO 11612 for heat and flame or to AS/NZS 4602.1 for high visibility, and no certificate has been sighted. If your site specifies certified trousers, these are not them.
- No abrasion figure: no Martindale cycle count to ISO 12947, no denier, no fibre percentages. "Wear-resistant" is the supplier's wording, not a tested result, and this page does not treat it as one.
- Not waterproof: no water-resistance rating is published for this garment. In rain, treat them as ordinary trousers.
- Tactical is a style: the camouflage and multicam prints are a fabric pattern and nothing more. These are commercial trousers sold to the public. They are not issued kit, they carry no armed-forces approval, and nothing on this page should be read as claiming one.
- No knee pads: the knee panel is an extra layer of fabric, not padding. No pads are included and the supplier does not state whether there is an internal pocket to hold one.
- Sizing runs small: M is a 76 cm (760 mm) waist and 3XL is 94 cm (940 mm). Measure a pair that already fits you and compare it against the chart rather than buying the size on your usual label.
- Belt not included: the belts, boots and gloves in the photographs are not part of this listing.
- Two builds in the gallery: some photographs show a version with black contrast panels at the hip and knee, and the studio photographs show those panels in the same colour as the trousers. The supplier does not say which build ships with which colourway.
Q & A
Will these do for site work?
For general work and outdoor use, yes. They are not certified workwear — there is no flame resistance, no cut resistance, no hi-vis and no AS/NZS or ISO marking printed on the garment. If your site specifies a standard for trousers, these do not meet it and the page will not pretend otherwise.
What size do I take?
Go off the chart in the Specs tab rather than the size you normally buy, because these run small. M is a 76 cm (760 mm) waist and 3XL is 94 cm (940 mm). The supplier allows 1 to 3 cm (10 to 30 mm) variation on a hand measurement, so treat the figures as close rather than exact.
What are they actually made of?
The supplier publishes no fibre content for this listing. What the images show is a ripstop weave with a second textured layer over the knee and shin. There is no percentage on this page because there is no percentage on the artwork.
Are they waterproof?
No. No water-resistance rating is published for them, so rain will come through much as it would through any ordinary trouser. If you need to stay dry, these are not the layer that does it.
How long is the leg?
Total length runs 101 cm (1010 mm) at M through to 109 cm (1090 mm) at 3XL. That is the whole trouser as the supplier measures it, not an inseam, so measure a pair you already own the same way before you compare.
Will they take knee pads?
The knee panel is a second layer of fabric rather than padding, and no pads come with them. The supplier does not state whether there is an internal pocket sized to hold a pad, so we cannot tell you either way.
Specs
| Specification | Detail |
|---|---|
| Garment | Men's cargo work trousers |
| Fabric | Ripstop weave, visible in the supplier images |
| Fibre content | Not specified by supplier |
| Fabric weight | Not specified by supplier |
| Abrasion resistance | Not specified by supplier — no Martindale or denier figure published |
| Water resistance | Not specified by supplier — no rating published |
| Knee | Articulated, with a second textured fabric panel over the knee and shin |
| Seat | Shaped yoke panel |
| Closure | Zip fly closing to a button at the waistband |
| Waistband | Belt loops plus webbing loops for a wider belt |
| Pockets | Thigh cargo, lower-leg and rear pockets, all under flaps. Total count not specified by supplier |
| Hem | Adjustment tab at each cuff |
| Colourways | Black, Grey, Dark Grey, Khaki, Army Green, Dark Green, Camouflage, CP multicam |
| Sizes | M, L, XL, 2XL, 3XL |
| Waist, M to 3XL | 76 / 82 / 86 / 90 / 94 cm (760 / 820 / 860 / 900 / 940 mm) |
| Hip, M to 3XL | 104 / 108 / 112 / 116 / 120 cm (1040 / 1080 / 1120 / 1160 / 1200 mm) |
| Total length, M to 3XL | 101 / 103 / 105 / 107 / 109 cm (1010 / 1030 / 1050 / 1070 / 1090 mm) |
| Leg opening, M to 3XL | 19.5 / 20 / 20.5 / 21 / 21.5 cm (195 / 200 / 205 / 210 / 215 mm). The chart does not state whether this is measured flat or around the cuff |
| Measurement tolerance | Supplier allows 1–3 cm (10–30 mm) on a hand measurement |
| Certification | None. No standard is printed on the garment and no certificate has been sighted |
| Knee pads | Not included |
| Belt | Not included |
Payment & Security
Payment Methods
Your payment information is processed securely.
We do not store credit card details or have access to your credit card information.













